Operator`s manual

13se c t i O n 4 — cO n t r O l s & fe a t u r e s
Reverse Pedal
The reverse drive pedal is located on the right side of
the tractor along the running board. Ground speed
is also controlled with the reverse pedal. The further
downward the pedal is pivoted, the faster the tractor
will travel. The pedal will return to its original position

PTO/Blade Engage Lever

deck or other (separately available) attachments.


disengage the power to the cutting deck or other
(separately available) attachments.
NOTE: 

engine.
Parking Brake/Cruise Control Lever
The parking brake/cruise control lever is located

to engage the parking brake when the tractor is
at rest. Engaging the lever while the tractor is in
motion allows the tractor to remain at a constant
ground speed without applying pressure to the

of this manual for detailed instructions regarding
the parking brake as well as the cruise control
feature.
NOTE: 

to do so, the tractor will automatically decelerate to the fastest
optimal mowing ground speed
NOTE: The parking brake must be set if the operator leaves the
seat with the engine running or the engine will automatically
shut off.
WARNING! Never leave a running machine

brake, stop engine and remove key to prevent
unintended starting.
Low Gas Window
The low gas window is located at the rear of
the tractor. If the gas level is visible in this
window, the tank should be re-filled.
FILL TANK IF GAS
LEVEL IS SHOWN
IN WINDOW
Electric Lift Switch
ELECTRIC
DECK
LI
FT
RAISE
DECK
LOW
ER
DECK
T o
Oper
at e
Electri
c Deck
Lift
Height
A
dj ustment
Raise
Electri
c Deck
Lift
T o
T h e
Highe
st
Po sition.
Set
Cutting
Height.
Lower
Electri
c Deck
Lift
T o
Chosen
Cutting
Po sition.
The electric lift switch located in the right fender and is used to
raise and lower the deck. To lower the deck press down on the
front of the switch and to raise the deck push down on the rear of
the switch.
Cutting Height Lever
LO 1 2 3 4 5 HI
The cutting height lever is used to set the distance the deck can
be lowered. The cutting height lever can be set to six different
positions by moving the lever up or down to the desired setting.
Ignition Switch Module
WARNING! Never
leave a running
machine unattended.
Always disengage

engine and remove key to prevent
unintended starting.
To start the engine, insert the
key into the ignition switch and
turn clockwise to the 
position. Release the key into the

position once the engine has
fired.
To stop the engine, turn the ignition key counterclockwise to the

position.
CAUTION: 



Module and operating the tractor in 

.
Forward Drive Pedal
The forward drive pedal is located on the right side

drive pedal forward to cause the tractor to travel
forward. Ground speed is also controlled with
the drive pedal. The further forward the pedal is
pivoted, the faster the tractor will travel. The pedal

pressed.