Operator`s manual

27se c t i O n 7 — se r v i c e
Headlights

headlight bulbs is necessary.
Replace headlight bulbs as follows:
Fully raise the hood of the tractor.
Unplug the wire harness leads from the headlight socket 2.
terminals. Note which wire connects to each terminal
before disconnecting.
Rotate the socket assembly approximately  ⁄ turn to align
the socket tab with the reflector housing notch; then
withdraw the bulb and socket assembly from the reflector

4.
from the socket.
Align a locking post of the bulb base with the notch in the 5.
socket, then push the bulb inward and turn clockwise to

Align the socket tab with the notch of the reflector 6.
housing; then push the socket inward and turn as
necessary to lock the socket in the housing:
Connect the wire harness leads to the appropriate socket 7.
terminals.
Fuses
Always use the same capacity fuse for replacement. If the
electrical system does not function, check the fuses.
To replace a fuse, pull the old fuse from the fuse holder and
install the new fuse.
Cutting Deck Removal
WARNING! 


position and remove the key from the switch.
Disconnect the spark plug wire for additional safety.

surface.
NOTE: Carefully positioning a piece of 2x4 under the
center, rear of the cutting deck to raise it up slightly will aid
in completing the following steps.
WARNING! When handling the mower deck, be
careful not to cut yourself on the sharp blades. The
deck idler arm lever is spring loaded. Release it
slowly.
2.
lift switch to lower the lift links.
Working on the left side of the tractor, insert a  ⁄
ratchet wrench, set to loosen, into the square hole found
on the idler bracket.
4.

WARNING! Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and the pulley while installing the belt.
5.
Feed the belt forward and remove from around the mule 6.

clutch pulley.
Looking at the cutting deck from the left side of the tractor, 7.
locate the deck support pin on the rear left side of the deck.
Terminal
Socket Tab
Reflector Notch
Socket
Reflector Housing
Figure 7-2
Figure 7-3