Full Product Manual

9Section 2 — ASSembly & Set-Up
2. Stand behind the edger and hold the blade control against
the upper handle.
3. Gently pull the starter rope out of the engine.
WARNING! The edger blade WILL rotate when the
starter rope is pulled.
NOTE: The starter rope will not pull out of the engine
unless the blade control (refer to Figure 3-5) is depressed
against the upper handle.
4. Slip the starter rope through the top of the rope guide.
5. Tighten the wing knob which secures the rope guide to
the upper handle.
Adjustments
Bevel Adjustment
The angle of the edger blade can be adjusted by placing the
bevel adjustment in one of three positions for edging. See Figure
3-6.
Figure 3-6
Set-Up
Gas & Oil Fill-Up
Service the engine with gas and oil as instructed in the Engine
Operators Manual packaged separately with your edger. Read
Instructions carefully.
WARNING! Use extreme caution when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.