Use and Care Manual

Maintenance & Adjustments
6
15
WARNING! Do not — at any time — make any
adjustments without first stopping engine,
disconnecting spark plug and grounding it against
the engine. Always wear safety glasses during
operation or while performing any adjustments or
repairs.
Maintenance
Engine
Refer to the Engine Operator’s Manual for all engine maintenance
instructions.
Tire Pressure
See the sidewall of the tire for recommended pressure. Do not,
under any circumstances, exceed manufacturer’s recommended
psi. Maintain equal pressure on all tires.
WARNING! Excessive pressure when seating beads
may cause tire/rim assembly to burst with force
sufficient to cause serious injury. Refer to the
sidewall of tire for recommended pressure.
Hydraulic Fluid & Inlet Filter
Check the hydraulic fluid level in the log splitter reservoir
tank before each use. Maintain the fluid level within the range
specified on the dipstick at all times. Change the hydraulic fluid
in the reservoir every 100 hours of operation. Follow the steps
below:
1. Place a suitable oil collection container under the tank.
2. Disconnect the suction hose from the bottom of the
reservoir tank, and allow the fluid to drain into container.
3. Carefully un-thread the inlet filter and clean it with
penetrating oil. See Figure 6-1.
Suction
Hose
Inlet
Filter
Figure 6-1
4. Allow the fluid to drain into a suitable container.
5. Reinsert the filter and reconnect the hose. Fill the reservoir
as instructed in the Assembly & Set-Up section (Page 9).
Approved fluids include Shell Tellus® S2 M 32 Hydraulic
Fluid, Dexron® III/Mercon® Automatic Transmission Fluid,
Pro-Select™ AW-32 Hydraulic Oil or 10WAW-ISO Viscosity
Grade 32 Hydraulic Oil. Check the engine oil level. Refill if
necessary.
6. Maintain the fluid level within the range specified on the
dipstick at all times.
NOTE: Always dispose of used hydraulic fluid and engine
oil at approved recycling centers only.
7. Contaminants in fluid may damage the hydraulic
components. Flushing the reservoir tank and hoses with
kerosene whenever service is performed on the tank,
hydraulic pump or valve is recommended. Contact an
authorized service dealer.
Hydraulic Oil Filter
Change the hydraulic oil filter every 50 hours of operation. Use
only a 10 micron hydraulic oil filter. Order part number 723-0405.
Beam & Splitting Wedge
Lubricate both sides of the beam (where it comes into contact
with the splitting wedge) with engine oil before each use.
Hose Clamps
Before each use, check if the hose clamps on the suction hose
(attached to the side of the pump) are tight. Check the hose
clamps on the return hose at least once a season.
Off-Season Storage
If the log splitter will not be used for more than 30 days, prepare
for storage as follows:
WARNING! Never store machine with fuel in the
fuel tank inside of building where fumes may reach
an open flame or spark, or where ignition sources
are present such as hot water and space heaters,
furnaces, clothes dryers, stoves, electric motors, etc.
1. Clean the log splitter thoroughly.
NOTE: The use of a pressure washers or garden hose to
clean your log splitter is not recommended. They may
cause damage to bearings or the engine. The use of water
will result in shortened life and reduce serviceability.
2. Wipe the log splitter with an oiled rag to prevent rust,
especially on the wedge and the beam.
3. Store the log splitter in a clean, dry area. Do not store next
to any corrosive materials, such as fertilizer.
NOTE: If storing in an unventilated or metal storage shed,
be certain to rustproof the equipment by coating with a
light oil or silicone.