Use and Care Manual

10 Section 3— ASSembly & Set-Up
3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder screws and flange
lock nuts. Be careful not to crimp or damage the wire
harness while installing the seat. See Figure 3-3.
Figure 3-3
4. Using the harness clip attached to the harness, secure the
excess wire to the fender by snapping the harness clip in
place as shown in Figure 3-4.
Figure 3-4
Lower Deck Discharge Chute Deflector
WARNING! Never operate the mower deck
without the chute deflector installed and in the
down position.
Check the mower deck for shipping braces (with tags) that may
be holding the chute deflector upward for shipment If a braces
are present, they must be removed before operating the tractor.
Holding the chute deflector fully upward, remove the shipping
brace by grasping it and rotating it clockwise. Lower the chute
deflector. See Figure 3-5.
Figure 3-5
Installing the Hood Topper (If necessary)
To install the hood topper (1), line up the holes on the hood
topper (1) up with the tabs (2) in the hood frame as shown in
Figure 3-6. Insert the tabs (2) into the hood topper and pull back
to lock into place.
1
2
2
2
2
Figure 3-6