Use and Care Manual
8 Section 3 — ASSembly & Set-Up
Attaching the Cable
To attach the cables, follow these steps:
Route the cable along the handle assembly on the right-
Forward
Drive Cable
Clutch Bail
Cable Mount
Figure 3-2
2. Connect the forward drive cable to the clutch bail by
feeding the z-hook through the hole on the clutch bail
Snap the cable housing clips into the handle assembly
NOTE: To test the function of the clutch bail, lift the bail
to the handle and release it. The bail should return to its
technical assistance.
4. Clip the cable into the cable guide located on the handle
Figure 3-3
Move Tiller Off Crate
To roll the tiller off the shipping platform, put the wheels in
freewheel, if they are not already from the factory, as follows:
Place a sturdy block under the transmission to raise one
Remove the click pin
from the wheel hub
Slide the wheel fully
inward on the wheel
shaft . Reinstall the
click pin
Click Pin
Figure 3-4
2. Slide the wheel fully inward on the wheel shaft . Reinstall
the click pin through the wheel shaft only (not through the
(freewheel) on the wheel shaft. Repeat with the other wheel.
Use the handlebar to roll the tiller to a flat area.
NOTE: Before starting the engine, the wheels must be
placed in the WHEEL DRIVE position (pins through wheel
hubs and wheel shaft).
4.
WHEEL DRIVE position, remove the click pin, slide the
wheel fully inward and reinstall the click pin.