Use and Care Manual

Section 6 — Maintenance & adjuStMentS
23
4. Turn the water on.
5. 
engine and place the throttle in the FAST position.
6. 
7. 
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8. 
  position to turn the

 Turn the water off and detach the hose coupler from the

 

cutting deck running for a minimum of two minutes, allowing
the underside of the cutting deck to thoroughly dry.
Lubrication
WARNING! 

brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel axles and rims is equipped with grease
fittings. See Figure 6-4. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor operation.
Grease
Fittings
Figure 6-4
Steering Supports
Under the frame of the tractor there are two grease fittings for the
steering supports. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor operation.
See Figure 6-5.
Grease
Fitting
Figure 6-5
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Tires
WARNING! Never exceed the maximum inflation
pressure shown on the sidewall of the tire.

recommended or maximum psi. Do not overinflate. Uneven tire
pressure could cause the cutting deck to mow unevenly.