Use and Care Manual
10 Section 3— ASSembly & Set-Up
Steering Wheel
Remove the hardware for attaching the steering wheel
from beneath the steering wheel cap. Carefully pry off the
steering wheel cover to remove the hardware.
2. With the wheels of the tractor pointing straight forward,
place the steering wheel over the steering shaft.
Place the flat washer and belleville washer over the steering
Steering Wheel Cover
Hex Screw
Steering Wheel
Steering Wheel
Column
Belleville Washer
Figure 3-3
4. Place the steering wheel cover over the center of the steering
Install Operator’s Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan
attached. A second person may be needed to hold the seat.
Cut any straps securing the seat assembly to the tractor.
Remove any packing material.
NOTE:
seat and the seat switch in the bottom of the seat.
2. Remove the two shoulder screws and flange lock nuts in
Shoulder Screws
Flange Lock Nuts
Figure 3-4
Rotate the seat into position and secure the seat into place
with the previously removed shoulder screws and flange
Shoulder Screws
Flange Lock Nuts
Figure 3-5
NOTE:
harness into the seat box hole before continuing.