Full Product Manual

11
ASSEMBLY
Attaching the Seat Tether (ZT6 Models Only)
ZT6 Models are shipped with the seat folded forward, and the seat tether cable
detached from the seat pan.
1. Locate the seat tether cable. The lower end will be preinstalled on the inner
left side of the frame.
2. Using a 7/16” wrench and a 3/8” wrench remove the shoulder bolt and hex
lock nut from the left side of the seat pan.
3. Install the detached end of seat tether cable onto the seat pan with the
hardware previously removed as
shown in Figure 18:
a. Slide the cable onto the
shoulder bolt previously
removed.
b. Route the shoulder bolt
through the hole from the
inside outward.
c. Secure the cable with the
hex lock nut and torque
to 68-102 in-lbs (8-11.5
N-m).
Adjusting the Seat
1. Push left and hold
the seat adjustment
lever to adjust the
seat position.
2. Slide seat forward or
rearward to desired
position.
3. Release the
adjustment lever.
Ensure seat is locked
into position before
operation. See
Figure 19.
Adjusting the Mechanical Suspension Mechanism (ZT6 Models
Only)
The mechanical suspension
mechanism (if equipped)
incorporates weight/ride
adjustment controls for operators
in the 125 to 275 lb. (57-124 kg)
weight range. Turn the knob on
the front of the seat clockwise to
increase the weight capacity and
counter-clockwise to decrease.
See Figure 20.
Note: The seat base must be
secured by the latch, otherwise, the seat assembly could tilt forward. The Operator
Presence Sensor must be connected to the electrical wiring harness.
Figure 18
Figure 19
Figure 20