Full Product Manual

19
SERVICE AND MAINTENANCE
Note: This Operator’s Manual covers several models. Tractor features may vary by
model. Not all features in this manual are applicable to all tractor models and the
tractor depicted may differ from yours.
Post-Operation Tractor Care
After each operation of the tractor, to ensure safe operating conditions refer to
Maintenance Schedule chart in this manual for proper tractor care.
WARNING
Failure to follow these recommendations may result in serious injury to
yourself or others and may cause damage to the tractor.
Cleaning the Tractor
WARNING
If the tractor has been recently run, the engine, muffler and surrounding
metal surfaces will be very hot and can cause burns to the skin. Let the
engine cool for at least five minutes. Exercise caution to avoid burns.
Your tractor should be cleaned after each use and under certain conditions, i.e. dry
conditions and/or mulching situations, additional cleaning may be necessary.
One of the best ways to keep your tractor running efficiently and to reduce fire risk
is to regularly remove debris buildup from the tractor. Follow the recommendations
below and contact your authorized dealer with any questions.
• Allow the machine to cool for at least five minutes in an open area before
cleaning.
Note: Using a pressure washer or
garden hose is not recommended
for cleaning your tractor other
than to clean the underside of
the deck. It may cause damage to
electrical components, spindles,
pulleys, bearings or the engine.
The use of water will result
in shortened life and reduce
serviceability.
• Keep both sides of
transmission cooling slots,
exhaust manifold, around
fuses, all wiring and
harnesses, muffler pipe,
muffler shield, engine
intake screens and cooling
fins, etc. clear of grass
clippings and leaves. See
Figure 33.
• Clean the top of the mower
deck, under the spindle
covers and belt area. See
Figure 34.
Figure 33
Figure 34
• Clean around and near
the transmission, axle
and the fan area. See
Figure 35.
• Debris can accumulate
anywhere on the
tractor, especially on
horizontal surfaces.
Additional cleaning
may be necessary
when mowing in dry
conditions or when
mulching.
• Fuel leaks/spills, oil leaks/spills and excess lubrication can also become
collections sites for debris. Immediate repair and cleaning up oil or fuel spills
can help reduce fire hazards.
• In addition to cleaning the tractor before operating and storing, do not
attempt to mow unusually tall grass (10” (25.4 cm) or higher), dry grass (e.g.,
pasture) or piles of dry leaves. Dry grass or leaves may contact the engine
exhaust and/or build up on the mower deck presenting a potential fire
hazard.
Storing the Tractor
• Allow the machine to cool in an open area for at least five minutes before
storing.
• Do not park the tractor near any flammable materials (wood, cloth or
chemicals) or any open flames or other potential source of ignition (furnace,
water heater or any other type of heater).
• Remove all combustible materials from the tractor before storing. Empty
cargo boxes, grass catchers or containers.
• Always shut off fuel flow when storing or transporting if tractor is equipped
with a fuel shutoff.
• Check the fuel system (lines, tank, cap and fittings) per the maintenance
schedule for cracks or leaks. Repair and clean as necessary.
Maintenance
Removing the Floor Panel
WARNING
Do not operate tractor with floor panel removed.
The floor panel can be removed for maintenance, service and cleaning. To remove
the floor panel:
1. Carefully lift the rear of
the floor panel. See 1 in
Figure 36.
2. Slide the floor panel
rearward to free the
front of the floor panel.
See 2 in Figure 36.
3. Lift it off the tractor. See
3 in Figure 36.
4. To place the floor panel
back on the tractor,
carefully fit the front
tabs at the front of the
floor panel into place
and lower the rear of the
panel down into place.
Wheel Not Shown For Clarity
Figure 35
1
2
3
Figure 36