Operator`s manual

24 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t s
Setting the Deck Wheels
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows

the deck lift pedal in the normally desired mowing height
setting.
Check the deck wheels for contact or excessive clearance 2.
with the surface below. The deck wheels should have

If the deck wheels have excessive clearance or contact with 
the surface, adjust as follows:
Raise the deck lift pedal to its highest setting.a.
Remove the front and rear deck wheels by removing b.
the lock nuts and shoulder bolts which secure them

c.
height setting.
Reinsert the shoulder bolts (with each gauge wheel) d.
into the index hole that leaves approximately
½-inch between the bottom of the wheel and the
pavement.
Parking Brake Adjustment
If the tractor does not come to a complete stop when the brake

roll with the parking brake applied (and the hydrostatic relief

Cadet dealer to have the brake properly adjusted.
Lock Nut
Shoulder Bolt
Deck Wheel
Figure 6-9