Operator`s manual

27se c t i O n 7 — se r v i c e
Replacing the Deck Belt
Remove the deck from beneath the tractor, (refer to Deck 
Removal on page 24).
Remove the hex washer screws securing the belt covers to 2.
the deck.
Using a  ⁄
male end into the ⁄

While holding the idler arm back, loosen the deck belt from
the pulley and slide the belt away from the pulley.
Install the new deck belt around the spindle pulleys as 4.
shown in Fig. 7-8 and reinstall the belt covers.
Reinstall the deck following the instructions in Deck 5.
Installation on page 25.
Replacing the PTO Belt
Remove the deck from beneath the tractor, (refer to Deck 

2.
instructions in Deck Installation on page 25.
Mower Blade Care
WARNING! 
gloves when handling the blades. When servicing
the mower deck, be careful not to cut yourself on
the sharpened blades.

cutting edges of the blades evenly so that the blades remain
balanced and the same angle of sharpness is maintained.
If the cutting edge of a blade has already been sharpened many
times, or if any metal separation is present, it is recommended
that new blades be installed. New blades are available at your
authorized dealer.
After all four cotter pins are secure, slide the deck forward 5.
and hook the deck to the U-rod.
6.
⁄
bracket and turn towards the back of the tractor to finish
routing the belt around the idler pulley.
7.
the click pin and push the pedal forward and rock back to
lock into the transport position, locking behind the notch
on the front of the index plate.
Refer to the Maintenance & Adjustments section to level 8.
the deck if required.
Make sure the proper tension is on the belt. To adjust the 

NOTE: 
routing to make sure that the belt has been routed
properly.
PTO Pulley
PTO Belt
Deck Belt
Figure 7-8
Idler Arm
Figure 7-9