Operator`s manual
28 se c t i O n 7— se r v i c e
The blades may be removed as follows.
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 24) then gently flip the deck over to
expose its underside.
Use a 2. ⁄
assembly when loosening the hex nut securing the blade.
A block of wood may be placed between the deck housing
and the cutting edge of the blade to help in breaking loose
the hex nut securing the blade. To reinstall the blades,
Reinstall the deck (refer to Deck Installation on page 254. ).
NOTE: Add a small amount of multi-purpose grease to the
bolt threads to avoid corrosion and galvenic action.
WARNING!:
that are bent should be replaced. The cutting blades
are sharp and can cause severe injury. Wrap the
cutting surface of the blade with a rag to avoid injury.
Sharpening the Blades
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 24) then gently flip the deck over to
expose its underside.
Clean any debris from the blades. Keep blades sharp and
free of build up at all times.
2.
balanced cutting blades. Do not sharpen the underside of
the blades. Use a electric blade sharpener, a conventional
electric grinder or a hand file to sharpen the blades.
Replace any blade with severe nicks or dents that cannot
be removed by filing.
Check the balance of the blade after sharpening by placing 4.
it on a blade balancer. Do not use unbalanced blades.
If the blade dips on one end, file stock off of the cutting 5.
surface on that end.
NOTE: Replace any blades that cannot be easily balanced.
Changing the Spindle Assembly
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 25).
Remove the hex washer screws securing the belt covers 2.
to the deck and remove the belt from the spindle pulleys.
2.
Use a ⁄
assembly when loosening the hex nut securing the blade.
A block of wood may be placed between the deck housing
and the cutting edge of the blade to help in breaking loose
NOTE: Take note of the order that the parts composing the
assembly are placed.
Using a wrench or socket ratchet remove four hex washer 4.
Reverse the process to install the spindle assembly.5.
Changing the Transmission Drive Belt
Cub Cadet dealer to have the transmission drive belt replaced.
Hex Washer
Screw
Spindle Assembly
Blade
Flange Lock Nut
Figure 7-10
Hex
Washer
Screw
Spacer
Pulley
Hex Screw
Spacer
Spindle Assembly
Spacer
Blade
Flange Lock Nut
Figure 7-10