User's Manual

Documents Title
Rev
V1.3
BLE Tire Pressure Monitoring System
User Manual
Date
Jul 9, 2014
Page
4/13
4
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions for
satisfying RF exposure compliance. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
2.2 Product Warning
2.2.1 Do not operate APP while driving, the company is exempt from all
consequences because of driver’s careless and improper operation.
2.2.2 The system adopts the wireless transmission of signals. In some special
environment, frequency interference or wrong operation or wrong installation may
cause signal weaker or no signal. If the insulation adhesive sticker of the windshield
contains metal material, it will affect signal reception. When it alarms sound and
shows abnormal data, please drive the vehicle away from the current location
(there may be signal interference in the neighborhood) or drive the vehicle to a tire
shop to check.
2.2.3 The battery status of the TPMS sensor is low (abnormal condition exists, the battery
may make the TPMS sensors continuously emit signals to warn the driver, so that
battery life is shorter than expected life), please go as soon as possible to the
specified service station to confirm whether the TPMS sensor need to be replaced.
2.2.4 Please change the battery while battery power is low, and change the sensor while
low sensor battery warning is alarmed, it may cause the TPMS not working
normally. You will take all risks and responsibilities for this!
2.2.5 Temporary resealing or re-inflation product injected through valve hole may
adversely affect the operation of the sensor. The company is exempt from all
consequences
2.2.6 Do not place the TPMS sensor in contact with chemicals, it would cause sensor
damaged and cannot function properly.
2.2.7 Please close the other APPs or web pages which are not in use when using BLE
APP, data receiving condition on APP will probably be affected by the system
loading of the smart phone.
3. BLE TPMS Specification
BLE Sensor Specification
Operating Voltage
3V