AK80-64 AK Series Actuator Driver Manual V1.0.8
Table Of Contents
- Notice
- 1.Ensure that the circuit is normal and the interfac
- 2. The driver board will be hot when output, pleas
- 3. Please Check whether the parts are in good cond
- 4. Several optional control modes can’t be switche
- 5. Please use it strictly in accordance with the w
- Feature
- Disclaimer
- Version Change Record
- 1.Drive Product Information
- ①Three-phase wires connection port
- 2.R-link produce information
- 2.1 Introduction of R-link' appearance&Specificat
- 3. Actuator and R-link Connection and Notices
- Connection instructions: Connect the USB cable to
- 4. Instructions for use of the upper computer
- 1.Click Open File and select the firmware. The firmw
- 2.Click Bootloader.
- 3.Click download and wait for the progress bar to re
- 5. Driver board communication protocol and descrip
https://www.cubemars.com/
19 / 52
4.1.1.7 Import Settings
Upload the parameters of the two files with the suffix ".McParams" and
".AppParams" on the computer to the upper computer.
4.1.1.8 Restore Factory
This feature is not currently enabled.
4.1.1.9 Mode Switch
This page is mainly about switching the control mode of the drive board,
including "guide mode", "servo mode" and "MIT power mode", and
update the driver board firmware.