AK80-64 AK Series Actuator Driver Manual V1.0.8
Table Of Contents
- Notice
- 1.Ensure that the circuit is normal and the interfac
- 2. The driver board will be hot when output, pleas
- 3. Please Check whether the parts are in good cond
- 4. Several optional control modes can’t be switche
- 5. Please use it strictly in accordance with the w
- Feature
- Disclaimer
- Version Change Record
- 1.Drive Product Information
- ①Three-phase wires connection port
- 2.R-link produce information
- 2.1 Introduction of R-link' appearance&Specificat
- 3. Actuator and R-link Connection and Notices
- Connection instructions: Connect the USB cable to
- 4. Instructions for use of the upper computer
- 1.Click Open File and select the firmware. The firmw
- 2.Click Bootloader.
- 3.Click download and wait for the progress bar to re
- 5. Driver board communication protocol and descrip
https://www.cubemars.com/
4 / 52
Notice
1. Ensure that the circuit is normal and the interface is correctly
connected as required.
2. The driver board will be hot when output, please use it carefully to
avoid burns.
3. Please Check whether the parts are in good condition before use. If
any parts are missing or aging, please stop using and contact technical
support in time.
4. Several optional control modes can’t be switched when driver board is
working, and different control mode have different communication
protocol. If you need to switch, please reboot the power to the diver
board then to change. Using the wrong protocol control may burn the
driver board.
5. Please use it strictly in accordance with the working voltage, current,
temperature and other parameters specified in this article, otherwise it
will cause permanent damage to the product.