User Manual

ManualsBrandsCubic Transportation Systems ManualsElectronicsAccess Control Card Reader

Table Of Contents

REVISION DATE DOCUMENT NAME DOCUMENT NUMBER PAGE

E.00 06 Apr 05

Installation Guide for the Small GO CARD Access Control Target

061-9214 4

Table 1. ACT Terminal Block Wiring Connections (Configuration 1)

Terminal Function Comment

1 Internal 5 volts Provides +5 volts at up to 100 mA

2 External 5 volts Isolator and LED power (Requires +5 volts at 20 mA)

3 Data 1 Optically isolated data out

4 Data 0 Optically isolated data out

5 LED High = Red, low = Green, unconnected = Yellow

6 External Common Isolator and LED power and data signal common

7 Power Common Unit power and internal +5 volt common

8 Unit Power Requires from +8 to +28 volts at up to 2.5 watts

2.2 WIRING FOR CONFIGURATION 2

Connections are as shown in Table 2 along with the following considerations:

1. Power is supplied on pins 7 and 8.

2. If the ACT is used with an existing access controller, pins 2 through 6 of the ACT are connected to the

access controller standard five-wire interface.

3. If the controller used does not require optical isolation and does not provide 5 volt power, connect pin 2

to pin 8 and pin 6 to pin 7. This uses the reader’s external power for the optical isolator and the LED,

but defeats the optical isolation by connecting the signal and power grounds.

4. If the ACT is programmed (via an activation card) to output Wiegand data, the data output appears on

pins 3 and 4. If the unit is programmed to output serial or magnetic-stripe data, the data appears only

on pin 3.

Table 2. ACT Terminal Block Wiring Connections (Configuration 2)

Terminal Function Comment

1 Test For production use

2 External 5 to 28 volts Isolator and LED power (Requires 5 to 28 Vdc at 20 mA)