User Manual

REVISION DATE DOCUMENT NAME DOCUMENT NUMBER PAGE
E.00 06 Apr 05
Installation Guide for the Small GO CARD Access Control Target
061-9214 1
1. INTRODUCTION
1.1 PURPOSE AND SCOPE
The purpose of this manual is to provide instructions for the installation of the Cubic GO CARD
®
Access Control
Target hardware.
The scope of this manual includes the installation and configuration of the hardware mounting, wiring, and setup.
NOTE
The Access Control Target is intended for professional installation
only.
1.2 ABBREVIATIONS AND ACRONYMS
A ampere
ACT Access Control Target
cm centimeter
Cubic Cubic Transportation Systems, Inc.
dc direct current
in. inch
LED Light Emitting Diode
mA milliampere
MHz megahertz
RF Radio Frequency
Vdc volts, direct current
This document contains proprietary and confidential information originated or owned by Cubic Transportation Systems, Inc. (Cubic). Neither this document nor the information disclosed
herein shall be reproduced or transferred to other documents or used or disclosed to others for manufacturing or any other purposes except as specifically authorized in writing by Cubic.