User Manual

REVISION DATE DOCUMENT NAME DOCUMENT NUMBER PAGE
E.00 06 Apr 05
Installation Guide for the Small GO CARD Access Control Target
061-9214 3
2. ACCESS CONTROL UNIT INSTALLATION
The assembly part number 061-1311 is a small Access Control Target (ACT) or reader that emulates a Wiegand
card reader. The ACT connects to a standard five-wire Wiegand interface and to an 8 to 28 volt auxiliary power
supply via an 8-pin terminal block.
The reader generates a 13.56 MHz RF field and reads standard GO CARD System Access Cards at distances up
to 4 cm.
The reader has the same area as a single-gang wall plate (2.75 in. W x 4.5 in. H x 1.5 in. D) and surface mounts
using two mounting holes. The mounting holes match the holes in a single-gang electrical utility box.
The reader is wired into the system using its internal 8-pin terminal block. It is important to note, there are two
configurations of the ACT for wiring purposes. Use the label on the back of the ACT to determine the wiring
needs.
Configurations are shown in Figure 1 and Figure 2.
Figure 1. Configuration 1 Figure 2. Configuration 2
2.1 WIRING FOR CONFIGURATION 1
Connections are as shown in Table 1 along with the following considerations:
1. Power is supplied on pins 7 and 8.
2. If the ACT is used with an existing access controller, pins 2 through 6 of the ACT are connected to the
access controller standard five-wire interface.
3. If the controller used does not require optical isolation and does not provide 5 volt power, connect pin 1
to pin 2 and pin 6 to pin 7. This uses the reader’s internal 5 volts for the optical isolator and the LED but
defeats the optical isolation by connecting the signal and power grounds.
4. If the ACT is programmed (via an activation card) to output Wiegand data, the data output appears on
pins 3 and 4. If the unit is programmed to output serial or magnetic stripe data, the data appears only
on pin 3.
This document contains proprietary and confidential information originated or owned by Cubic Transportation Systems, Inc. (Cubic). Neither this document nor the information disclosed
herein shall be reproduced or transferred to other documents or used or disclosed to others for manufacturing or any other purposes except as specifically authorized in writing by Cubic.