User's Manual
Table Of Contents
FCC Statement 
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
(1) This device may not cause harmful interference. 
(2)  This  device  must  accept  any  interference  received,  including  interference  that  may  cause 
undesired operation. 
2.  Changes  or  modifications  not  expressly  approved  by  the  party  responsible  for  compliance 
could void the user's authority to operate the 
equipment. 
NOTE: 
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. 
These  limits  are  designed  to  provide  reasonable  protection  against  harmful  interference  in  a 
residential installation. 
This equipment generates uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular 
installation. If  this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of 
the following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the  equipment into an  outlet  on  a  circuit different  from that to which the  receiver  is 
connected. 
Consult the dealer or an experienced radio/TV technician for help. 
Body-worn Operation 
This  device  was  tested  for  typical  body-worn  operations.  To  comply  with  RF  exposure 
requirements, a minimum separation distance 
of 5mm must be maintained between the user’s body and the handset, including the antenna. 
Third-party belt-clips, holsters, 
and  similar  accessories  used  by  this  device  should  not  contain  any  metallic  components. 
Body-worn accessories that do not meet these 
requirements may not comply with RF exposure requirements and should be avoided. Use only 
the supplied or an approved antenna. 










