Use and Care Manual
12
※ As shown in the figure above,
turn the knob counterclockwise
to open the lid.
※ Please check that the pressure
indicator piston is down before
turning.
When the pressure indicator is
up, residual pressure remains
inside and the top cover will not
turn.
※ If the pressure indicator is up,
remove the pressure by turning the
pressure weight in the “VENTING”
direction and open the top cover.
※ Check if the triangle mark on
the top cover and the triangle
mark (lock) on the body match
when closing/opening as
shown in the picture on the
right.
※ Open the top cover after turning it
completely as shown in the picture.
When the pressure indicator is down
When the pressure indicator is up
< CLOSE >
< OPEN >
- Match the "triangle down" on the lid with the "triangle up open lock" icon.(Refer to Fig.1)
Gently press and turn the handle towards to clockwise direction to close the Lid.(Refer to Fig.2)
- If icons are not aligned properly and lid is turned by force and malfunction and excess debris may form.
There may be leftover manufacturing residue within Multicooker parts that may change the taste of your dishes. To prevent this, please
thoroughly wash you inner pot before use.
- How to clean stainless steel parts(Inner pot, lid, steam rack etc.)
① Apply a small amount of cooking oil to a soft sponge or kitchen towel and wipe it clean.
② Wash thoroughly again with baking soda or kitchen detergent.
③ Repeat step ① & ② two times
- How to clean other parts(Heating plate, pot case etc.)
① Use dry clothes to gently wipe down any residues on the surface.
② If use wet clothes, completely dry the moisture with dry clothes before using.
If not placed properly :
- Gaps may form in the lid tracks causing lid to stop and not fully close.
If the lid is placed on properly: :
- Lid will close smoothly on the body.
Fig.1
Fig.2