INSTRUCTION BOOKLET Cast-Iron Burners CB-60/CB-30 For your safety and continued enjoyment of this product, always read the Instruction Book carefully before using.
IMPORTANT SAFEGUARDS 16. To disconnect, turn temperature control dial(s) to off, then remove plug from wall outlet. 17. C lose supervision is necessary when any appliance is used by or near children. When using electrical appliances, basic safety precautions should always be taken, including the following: 18. D o not operate your appliance in an appliance garage or under a wall cabinet. When storing in an appliance garage, always unplug the unit from the electrical outlet.
CONTENTS GROUNDING INSTRUCTIONS Important Safeguards.................................... 2 For your protection, Cuisinart Cast-Iron Burners are equipped with a 3-conductor cord set having a molded 3-prong grounding-type plug, and should be used in combination with a properly connected grounding-type outlet as shown in Figure 1. If a grounding-type outlet is not available, an adapter, as shown in Figure 2, may be obtained to enable a 2-slot wall outlet to be used with a 3-prong plug.
Parts and Features 1. Large cast-iron burner and burner ring 4. P ower On indicator light 5. R eady indicator light 2. Small cast-iron burner and burner ring 6. N onskid feet 3.
OPERATION • Do not leave the unit on without any pots/pans on the solid burners after the initial burn-off process. Before plugging in your cast-iron burner, check to ensure that the electrical circuit is not overloaded with other appliances. This unit should always be operated on a separate 120 volt 60 Hz AC circuit. Be certain that your cast-iron burner is resting level on the countertop. There is one burner ring on the CB30 and two burner rings on the CB60.
LIMITED THREE-YEAR WARRANTY purchase, and any other information pertinent to the product’s return. (U.S. and Canada only) CALIFORNIA RESIDENTS ONLY: California law provides that for In-Warranty Service, California residents have the option of returning a nonconforming product (A) to the store where it was purchased or (B) to another retail store that sells Cuisinart products of the same type. This warranty is available to consumers only.
other than ordinary household use. This warranty excludes all incidental or consequential damages. Some states do not allow the exclusion or limitation of these damages, so these exclusions may not apply to you. You may also have other rights, which vary from state to state.
©2016 Cuisinart 150 Milford Road East Windsor, NJ 08520 Printed in China Trademarks or service marks of third parties used herein are the trademarks or service marks of their respective owners.
MANUAL DE INSTRUCCIONES Hornillo eléctrico con placas de hierro fundido CB-60/CB-30 Para su seguridad y para disfrutar plenamente de este producto, siempre lea cuidadosamente las instrucciones antes de usarlo.
MEDIDAS DE SEGURIDAD IMPORTANTES aparato para permitir que el aire circule libremente alrededor del mismo. 15. No utilice el aparato para ningún otro fin que no sea el indicado. Este aparato ha sido diseñado para uso doméstico solamente. 16. Siempre apague el aparato, poniendo el/los control(es) de temperatura en “OFF”, antes de desconectarlo. Al usar aparatos eléctricos, siempre debe tomar precauciones básicas de seguridad, incluso las siguientes: 17.
ÍNDICE INSTRUCCIONES DE PUESTA A TIERRA Medidas de seguridad importantes............... 2 Para su protección, este aparato está equipado con un cable de puesta a tierra, con clavija de tierra, la cual debe ser conectada a una toma de corriente debidamente puesta a tierra (Fig. 1). Si una toma de corriente puesta a tierra no está disponible, se podrá usar un adaptador para conectar el aparato a una toma de corriente polarizada (Fig. 2).
PIEZAS Y CARACTERÍSTICAS 1. Placa grande de hierro fundido 4. Luz de encendido 5. Luz de listo 2. Placa pequeña de hierro fundido 6. Pies antideslizantes 3.
AVISOS IMPORTANTES INSTRUCCIONES DE OPERACIÓN • Antes del primer uso, caliente las placas (sin colocar nada encima) a la temperatura máxima por aproximadamente 4 minutos; esto quemará cualquier residuo presente sobre las placas. Antes de enchufar el aparato, averigüe que no hay otros aparatos eléctricos conectados al mismo circuito eléctrico, lo que podría provocar una sobrecarga eléctrica. Conecte este aparato a un circuito independiente de 120V AC (60 Hz).
Los residentes de California solo necesitan dar una prueba de compra y deben llamar al 1-800726-0190 para recibir instrucciones de envío. estropajos metálicos; esto puede rayar el acabado o dañar la unidad. 6. Seque completamente las placas y los aros. NOTA: para más seguridad, le aconsejamos que mande su paquete por un método de entrega con seguro y seguimiento. Cuisinart no será responsable por los daños ocurridos durante el transporte o por los paquetes mandados a una dirección equivocada.
Este aparato satisface las más altas exigencias de fabricación y ha sido diseñado para uso sobre corriente de 120V, usando accesorios y piezas de repuesto autorizados solamente. Esta garantía excluye expresamente los daños causados por accesorios, piezas o reparaciones no autorizados por Cuisinart, así como los daños causados por el uso de un convertidor de voltaje.
©2016 Cuisinart 150 Milford Road East Windsor, NJ 08520 Impreso en China Todas marcas registradas o marcas de comercio mencionadas en esta pertenecen a sus titulares respectivos.