manual

8
1. INTRODUCTION
You have just purchased a Cuisinart® juicer.
2. PRODUCT FEATURES
1. Lid
2. Juicing cone
3. Sieve
4. Container
5. Spout with anti-drip system
6. Release mechanism
7. Motor base
8. Cord winder (not shown)
3. USE
A. ASSEMBLING THE JUICER
• Rinse the lid, the juicing cone, the sieve and the
container in warm water. Do not rinse the motor
base in water but simply wipe it using a damp cloth.
• Fit the container onto the motor base. The three
plastic notches located on the bottom of the
container are inserted into the three holes located
on top of the motor base.
• Position the juicing cone on the top of the release
mechanism.
• Place the lid on the container.
• Plug the unit in. The juicer is ready to be used.
B. USING THE JUICER
• Place the unit on a horizontal, level surface.
• Remove the lid.
• Place a glass or other container under the spout.
• Set the spout to the open position.
• Cut the fruit horizontally.
• Place the centre of the fruit on the centre of the
juicer. Place your palm on the fruit.
• Press the fruit down rmly enough to activate the
release mechanism.
• When you feel the juicing cone through the skin of
the fruit, remove the fruit.
• Take another piece of fruit and repeat.
• After juicing approximately 200 gr of fruit (the
equivalent of 3 oranges), the sieve will appear to be
full.
• Remove the fruit from the juicing cone and place the
lid on the juicer. Press down on the cover to activate
the ‘fast spin’. This will release any juice remaining in
the sieve.
1
2
3
4
5
6
7
8