PROFESSIONAL POPCORN MAKER WPM40 Series For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
IMPORTANT SAFEGUARDS When using any electrical appliance, basic safety precautions should always be followed, including the following: 1. READ ALL INSTRUCTIONS BEFORE USING YOUR POPCORN MAKER. 2. Unplug main power cord from outlet while not in use and before cleaning. 3. To avoid any risk of electrical shock, do not immerse cord or plug into water or other liquid. 4. This appliance should not be used by or near children, or individuals with certain disabilities. 5. Do not touch hot surfaces.
14. Do not place the unit on or near a hot gas or electric burner or in a heated oven. 15. Extreme caution must be paid when moving the appliance containing hot oil or other hot liquids. 16. Turn ALL switches to OFF position before disconnecting power plug from the wall supply outlet. 17. Not recommended for outdoor use. 18. Do not use appliance for other than intended use. 19. To avoid overheating, always add oil and then kernels before operating. 20.
Parts 1. 3. 9. 4. 7. 5. 8. 6. 2. 12. 10. 13. 11. 1. 2. 3. 4. 5. 6. 7. Housing Kettle Gear Box Kettle Lid Axle Fixer Stirrer Retaining Pin 8. 9. 10. 11. 12. 13.
Assembling PRocedure Figure 1 Screw the kettle lid, axle fixer and stirrer onto the gear box. Figure 2 Hold the kettle on the supporter. Figure 4 Use the retaining pin to fix kettle at the right position. Figure 3 Insert the pin through the kettle and supporter. Figure 5 Finally, insert the internal kettle plug into the socket on the inner top of the popcorn maker housing.
POPPING INSTRUCTIONS 1. Make sure the popcorn maker is unplugged before you do any of the following. 2. Before using the unit, please check carefully if voltage (120V – 60 Hz ) is suitable to your home. 3. Clean the internal surface of the kettle with warm sudsy water, rinse well and dry with a clean cloth. Wipe down inner and outer housing with damp cloth. 4. Main unit has 2 function switches as follows: – Light/warmer combination – POP switch to turn heater and stirrer on 5.
13. Keep only the light/warmer switch on. 14. Remove plug from power supply if the unit is not being used. 15. Repeat steps 7 to 10 for continuous popping. Cleaning and Maintenance It is strongly recommended to clean the kettle frequently to avoid burning excess oil onto the bottom of the inner pot. After using the popcorn machine, use a wet cloth to clean the main unit, main body and glass. It is strongly recommended to wash and dry the tray after each use to avoid any bacteria buildup.
Any other trademarks or service marks of third parties herein are the trademarks or service marks of their respective owners. ©2009 Waring Products Division of Conair Corporation 150 Milford Road East Windsor, NJ 08520 www.waringpro.
