Use and Care Manual

8
BEFORE BREWING YOUR
FIRST POT OF COFFEE
Rinsing your coffeemaker: During the
manufacturing process, dust can get trapped
in the unit. We recommend flushing out the
system before brewing your first pot of
coffee. Simply fill the reservoir, power on the
unit, and follow steps 1, 3 and 5 on page 9
under MAKING COFFEE. Do not add coffee!
PROGRAMMING YOUR
COFFEEMAKER
SETTING THE CLOCK
When the coffeemaker is plugged in, 12:00
will flash in the display for 30 seconds,
indicating the unit is in Clock Set mode.
If 12:00 stops flashing, simply press the
MENU button 4 times to the CLOCK option
and the time will return to flashing Clock
Set mode.
Setting Hours and Minutes
Use the up arrow to set hour and the
down arrow
to set minutes. Hold buttons
down to scroll through the digits quickly, or
press and release to advance one digit at a
time. Be sure the PM indicator is on if
setting a PM time. Once time is correct,
press MENU to set. Five seconds after
finishing, the unit will automatically exit
Clock Setting mode.
SETTING THE AUTO ON TIME
1. Press and hold the AUTO ON button
for 2 seconds.
The digital display will flash the default
(12:00) or previously selected time.
Follow directions under SETTING THE
CLOCK (above) to program your start-
brew time. Five seconds after finishing,
the unit will automatically exit Auto On
Setup mode and the indicator light will
illuminate, letting you know AUTO ON
is activated.
NOTE: To exit AUTO ON Setup mode, you
can also just press AUTO ON button again.
2. To activate AUTO ON using previously
selected time:
Press the AUTO ON button.
Previously set time will appear and
indicator will light up. Display will return
to clock setting.
3. To deactivate AUTO ON:
Press illuminated AUTO ON button; light
will go off on LCD, indicating mode is
turned off.
Charcoal Water Filter
Your coffeemaker comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odors from tap water.
Inserting the Water Filter
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for 15
minutes.
• Lift the water filter holder out of the water
reservoir.
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running cold tap water
through holes in bottom of compartment
for 10 seconds.
• Allow the filter to drain completely.
•
Slide the water filter holder back into the
channel in the water reservoir, pushing it
down to the base of the unit
.
NOTE: We recommend
changing the water filter
every 60 days or after 60
uses, and more often if
you have hard water.
Replacement filters can
be purchased in stores, by
calling Cuisinart Customer
Service, or at
www.cuisinart.com