Manual

SLIDING UNDER CABINET ORGANIZER

Installation Guide for Models CTG-00-11CO, CTG-00-14CO, CTG-00-17CO

PARTS LIST

SEE REVERSE SIDE FOR INSTALLATION INSTRUCTIONS

1. Bottom wire basket (1)

REQUIRED TOOLS (not provided) – Drill, 1/8" Drill Bit, Screwdriver

2. Gliders (1 left/1 right) 3. Template (1)

4. 5/8" screws (8) 5. Basket mat (1)

PAGE 1
SLIDING UNDER CABINET ORGANIZER Installation Guide for Models CTG-00-11CO, CTG-00-14CO, CTG-00-17CO PARTS LIST 1. Bottom wire basket (1) 2. Gliders (1 left/1 right) 4. 5/8" screws (8) 3. Template (1) 5.
PAGE 2
INSTALLATION INSTRUCTION STEP 1 – Fold the front edge of STEP 2 – Place gliders (#2) template (#3) along the line between the “V” cutouts, and place inside the cabinet with folded edge at front edge of cabinet. Note the location of cabinet door hinges and adjust the template accordingly. in cutouts of template. The edges of gliders should align with edges of cutouts. Drill 1/8" pilot holes through 4 holes in glider. Repeat on the opposite side. Remove template after drilling pilot holes.