Owner Manual

Pasta Extruder Attachment
QUICK REFERENCE GUIDE
ASSEMBLY
1. Insert the feed screw, metal end first,
into the front end of the pasta extruder
body. Rotate until the plastic X on the
feed screw lines up with the X-shaped
groove inside the pasta extruder body.
2. Fit one of the pasta plates on top of the
feed screw. Make sure that the notches
on the four sides of the pasta plate slide
securely onto the four grooves on the
front end of the body.
3. Fit the ring nut over the pasta plate and
turn it clockwise until it is secured to the
body.
4. Attach the pasta cutter by sliding it over
the ring nut and aligning the two notches
on the side of the cutter with the two
grooves on the pasta extruder body.
Push firmly, and while pushing firmly,
turn the cutter clockwise to secure. It
should move freely around the pasta
plate and extruder body.
5. To switch the pasta plate, first remove
the pasta cutter, then the ring nut and
current pasta plate, then follow assembly
instructions 2 to 4 with the new pasta
plate. Make sure there is no pasta dough
obstructing the round groove located in
the center of the feed screw.
1. Make sure Stand Mixer is
OFF.
2. Gently pull outlet cover
off front of mixer head to
remove.
3. Turn the Stand Mixer
attachment knob
counterclockwise until outlet
opening is unobstructed.
4. Insert the assembled
extruder attachment into
the outlet opening, lining
up the square metal hub on
the extruder with the square
indentation in the outlet
opening.
5. Turn the Stand Mixer attachment knob
clockwise to secure to mixer.
ATTACHING TO STAND MIXER
IMPORTANT!
Do not discard. Read before operating your new Pasta Extruder Attachment.
Keep for further reference.
These helpful hints are intended to be a supplement to the Instruction Booklet.
In order to ensure proper operation and optimum performance, please read the
entire Instruction Booklet.