Owner's Manual

7
PROGRAMMING YOUR
COFFEEMAKER
TO SET THE TIME
Press and hold the HOUR or MINUTE button.
The clock will begin flashing.
1. Set Hour: Press and hold the HOUR button to
scroll through numbers quickly. When desired
number approaches, press and release the
button to advance one digit at a time.
NOTE: When the number count passes 12 PM
will be displayed on the LCD. Be sure the PM
indicator is on if a PM time is desired.
2. Set Minutes: Press and hold the MINUTE
button to scroll through numbers quickly.
When desired number approaches, press and
release the button to advance one digit at a
time. To finish setting time, simply wait until
the numbers stop flashing.
TO PROGRAM THE AUTO ON TIME
(BREW START TIME)
1. To set up the time for Auto On, hold the PROG
button until clock begins to flash. Set the time
you want coffee to begin brewing by using the
MINUTE and HOUR buttons.
Note: To use the previously selected Auto
On time again for Programming, simply press
PROG button once. The coffeemaker will
remember the time set previously unless
unplugged for more than 1 minute.
2. To activate Auto On mode, press the
PROG button and release. The blue PROG
indicator light will turn on to remind you that
the programming function is in use. At the
programmed time, the blue indicator light will
turn off and the blue BREW/OFF indicator light
will turn on, indicating that the brew cycle is
starting. The blue indicator light of BREW/
OFF button will turn off when Keep Warm
cycle ends.
NOTE: To turn off the Programming Function,
press the PROG button once. The blue PROG
indicator light should turn off.
BEFORE BREWING YOUR
FIRST POT OF COFFEE
We recommend flushing out the system before
brewing your first pot of coffee. Simply fill the
reservoir and power on the unit, following steps #2,
#4, #5 and #6 in BREWING COFFEE instructions on
the next page.
DO NOT ADD COFFEE!
Once you’ve done that, brew a pot
of coffee and get ready to enjoy
Cuisinart at its best!
CHARCOAL WATER FILTER
Your coffeemaker comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odors from tap water.
Inserting the Water Filter
• Remove the filter from the polybag and
soak it, fully immersed, in cold tap water
for 15 minutes.
• Lift the water filter holder out of the water
reservoir (see diagram, page 5).
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running cold
tap water through holes in
bottom of compartment for
10 seconds.
• Allow the filter to drain
completely.
• Slide the water filter holder
back into the channel in the
water reservoir, pu shing it
down to the base of the unit.
NOTE: We recommend
changing the water filter every
60 days or after
60 uses, and more often
if you have hard water.
Replacement filters
can be purchased in
stores, by calling
Cuisinart Consumer
Service, or at
www.cuisinart.com.