Specifications

Programming 23
Programming Mode Timeout
If no key activity occurs for a period of 180 seconds (3 minutes) while in programming mode, the mode will time out, exit the
programming mode and return to time of day display. Any setting that wasn’t saved by pressing the ‘Program’ key prior to the
control timing out will revert back to the previous value. (The few settings that had temporarily stored values will revert back to their
previous setting UNLESS the ‘Program’ key was pressed at the ‘Tank Size’ display.)
Regen Time Remaining
Upon exiting the programming menu, the current ‘Time of Day’ should be displayed on the display. If the unit is in regeneration,
pressing the “Regen” key will display how much total regeneration time remains. The display will stay active until the “Regen” key is
pressed again, or the regeneration ends (In Aqua-Sensor
®
mode, the total regeneration time remaining includes the full brine rinse
time, but will adjust accordingly upon auto rinse out).
Information Functions
While in the Information functions, all keys are active. The statistical functions are reached by pressing the “Information” key. The
information will have two operational modes; a standard information mode and a service information mode. Repetitive presses of
the “Information” key will cycle through the standard information mode until cycled back to time of day display. The service mode
information will be entered by an initial key press of the “Information” key and then successive presses of the “Down” key. While in
the service mode information, the functions will repeatedly cycle through the menus until the “Information” key is pressed again. The
following table outlines the Information function display, range limits and default setting.