Specifications
26 Culligan
®
Iron-Cleer
®
Plus Water Filters
Once either of the information menus is entered the information shown for each display is outlined below:
• Time Clock (standard information) - This display will only show when in time clock mode (no meter or Aqua-Sensor
attached). The display will alternate between ‘time’ and ‘clock’ every second until the ‘Information’ key is pressed or until the
function times out.
• Flow Rate (standard information) - This display will only show if the flow meter is attached to the control. The display shall
show the current flow rate of the water passing through the control. The display will show the “FLOW RATE” and “GPM” or
“LPM” icons and the current flow rate passing through the flow meter for as long as the “Down” key or “Information” key is not
pressed.
This display shall never time out, as opposed to the rest of standard information (10 minutes).
• Capacity Remaining (%)(standard information) -
This display will only show if the flow
meter is attached to the control. The display shows the percent capacity remaining in the
batch before regeneration will be triggered. The display will show the “SOFTWATER”,
“REMAINING” and “%” icons for softeners. This display shall never time out, as opposed
to the rest of standard information (10 minutes).
• Capacity Remaining (gal/L) (service information) - This display will only show if the
flow meter is attached to the control. The display shows the gallons or liters of capacity
remaining in the batch before regeneration will be triggered. The display will show the
“SOFTWATER”, “REMAINING”, and “GALLONS” or “LITERS” icons (depending on DIP
Switch # 7 setting) for softeners.
• Filter Media Life Remaining (service information) - This display will only appear in
the Filter Mode service statistics menu with flow meter attached and “LIFE” option set to
“Y”. It will compare the Total Flow since installation with the Total Capacity setpoint, and
display the gallons (liters) capacity remaining before triggering the alarm indicating that
service is required to replace the filter media. The display will first show “Life”, with the
“Water Usage”, “Remaining” icons for 2 seconds, followed by “Water Usage”, “Gallons”
(or Liters), and the capacity remaining for 10 seconds. This 2 and 10 second cycle
should repeat until the “Statistics” key or “Down” key is pressed, or the statistics time out
brings the display back to time of day. The “Change Media” code can be cleared while
in this display by pressing and holding the ‘Regen’ key for 10 seconds. Pressing and
holding the “Regen” key for 10 seconds while in this display will also reset the statistics
of “Total Flow / Life of Unit” and “Total Number of Regens / Life of Unit” back to zero
(whether the “Change Media” alarm has been triggered or not).
• Total Flow/Life of Unit (service information) - This display will only show if the flow
meter is attached to the control. The display will show a flow totalizer. The total amount
of flow that has passed through the unit since it was installed will be maintained. The
display will first show “totAL” for 2 seconds and then display the “GALLONS” or “LITERS”
icon (depending on dip # 7 setting) and the totalizer value for 10 seconds. This 2 and 10
second cycle should repeat until the “Information” key or “Down” key is pressed, or the
information time out brings the display back to time of day. If in filter mode with ‘LIFE’
option set to ‘Y’, pressing and holding the “REGEN” key for 10 seconds at the previous
display will reset this value back to zero.
098 7 6 5
%
%