Specifications
Introduction
4 Culligan Medallist Series
®
The Culligan Medallist Series
™
8” Water Softeners are tested and certied by WQA against NSF/ANSI
Standard 44 for the effective reduction of hardness (calcium and magnesium) and barium/radium as veried
and substantiated by test data.
The Culligan Medallist Plus Series
™
30, 45 and 60 Water Softeners are tested and certied by WQA
against NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnesium) and
barium/radium as veried and substantiated by test data.
The Culligan Medallist Plus Series
™
30, 45 and 60 Water Softeners are tested and certied by WQA against
NSF/ANSI Standard 61 for material requirements.
Hardness sample kits are available through your Culligan dealer.
For installations in Massachusetts, Massachusetts Plumbing Code 248 CMR shall be adhered to. Consult
your licensed plumber for installation of this system. This system and it’s installation must comply with state
and local regulations. The use of saddle valves is not permitted.
Safe Practices
Throughout this manual there are paragraphs set off by special headings. Example:
Note: Note is used to emphasize installation, operation or maintenance information which is important, but does not present any
hazard.
Caution! Caution is used when failure to follow directions could result in damage to equipment or property. Example:
Warning! Warning is used to indicate a hazard which could cause injury or death if ignored. Example:
Serial Numbers
• The control valve serial number is located on the back of the control.
• The media tank serial number is located on the top surface of the tank.
This publication is based on information available when approved for printing. Continuing design renement could cause changes
that may not be included in this publication.
Note: Check and comply with your state and local codes. You must follow these guidelines.
Caution! Disassembly while under water pressure can result in ooding.
Warning! Electrical shock Hazard! Unplug the unit before removing the cover or accessing any internal control
parts!
Note: The nipple must extend no more than 1 inch above the cover plate.
Note: Do not remove or destroy the serial number. It must be referenced on request for warranty repair or replacement.