Specifications

52 Culligan Medallist Series
®
Seal Pak Assembly
Follow the instructions for replacing the drive motor assembly through step 7, then continue as follows:
1. With the drive motor and backplate set aside, rmly pull the seal pack assembly from the valve body.
2. Lightly lubricate the o-rings of the replacement seal pack with silicone grease.
3. Reverse the procedure for reassembly.
Note: Use only silicone grease; petroleum-based lubricants will cause the degradation of the rubber components.
Caution! Do not twist the seal pack upon insertion. This can cause the outer o-rings to pinch, cut, or crimp.
Eductor Piston / Eductor Sleeve Assembly
Follow the instructions for replacing the drive motor assembly through step 7, then proceed as follows:
1. With the drive motor set aside, rmly pull the eductor piston & sleeve assembly from the valve body.
2. Lightly lubricate the o-rings of the replacement piston & sleeve assembly with silicone grease.
3. Reverse the procedure for reassembly.
Note: Use only silicone grease; petroleum-based lubricants will cause the degradation of the rubber components.
Note: The eductor piston and sleeve assemblies are unique to the softener, filter, and Super S
®
controls. Refer to the parts
list to ensure that the proper assembly is used.
Eductor Assembly
Refer to gure 13, page 20 and the following instructions for replacement of the eductor.
1. Remove the three screws and the eductor plate.
2. Remove the eductor screen by lifting it from the eductor body.
3. Remove the eductor body by grasping one of the projections with the pliers and gently pulling upward.
4. Reverse the procedure to reassemble. Be certain that the replacement eductor body contains the correct eductor nozzle.
Table 9 - Eductor Selection
Model Nozzle Color Nozzle with O-Ring P/N
8” Medallist Blue P1013894
30 & 45 Medallist Beige P1013895
60 Medallist Beige P1013895