Specifications

8 Culligan Medallist Series
Location
Space requirements - Allow 6-12 inches (15-30 cm) behind the unit for plumbing and drain lines and 4 feet (1.3 meters) above for
service access and lling the salt container.
Floor surface - Choose an area with solid, level oor free of bumps or irregularities. Bumps, cracks, stones and other irregularities
can cause the salt storage tank bottom to crack when lled with salt and water.
Drain facilities - Choose a nearby drain that can handle the rated drain ow (oor drain, sink or stand pipe). Refer to the Drain
Line Chart, Table 3 (page 25), for maximum drain line length.
Electrical facilities - A 10-foot cord and wall mount plug-in transformer are provided. The customer should provide a receptacle,
preferably one not controlled by a switch that can be turned off accidentally. Observe local electrical codes.
Note: The softener works on 24 volt - 60 Hz electrical power only. Be sure to use the included transformer. Be sure the
electrical outlet and transformer are in an inside location to protect from moisture. Properly ground to conform with all governing
codes and ordinances.
Note: P.N. 01018133 plug-in transformer is rated for indoor installations only.
P.N. 01015972 plug-in transformer is rated for indoor/outdoor installations.
Note: Most codes require an anti-siphon device or air gap. Observe all local plumbing codes and drain restrictions. The system
and installation must comply with all state and local laws and regulations.