Operating instructions

8 CULLIGAN MEDALLIST SERIES
™
FIG. 4 FIG. 5
FIG. 6
FIG. 7
CAUTION: When reinstalling back plate to control valve, make sure the u-clip
fully engages the two bottom holes of the bracket (Figure 6). Secure bracket from
the top with the two mounting screws provided.
CONNECT THE BRINE LINE
Refer to Figures 6 & 7.
• Measure a length of brine line sufficient to reach from the brine tank to the brine fitting, with no sharp bends. For
easier access to the float it is recommended to add an extra four feet (1.3 meters) of length to the brine line. Cut
both ends of the brine line squarely and cleanly.
• Remove the brine valve from the brine tank and then remove the white nut and insert from the float rod. Return
float rod to its original position.
• Slip the white nut over one end of the tubing and press the plastic insert into the end of the tubing (Figure 7).
Connect to the brine valve and tighten nut.
• Remove white nut and the plastic insert from the small parts pack.
• Slip the white nut over one end of the tubing and press the plastic insert into the end of the tubing (Figure 7).
Connect to the brine connection on the valve and tighten nut (Figure 6).