Operating instructions

SERVICE CHECK 21

The service mode allows one to view the instantaneous flow rate, the gallons remaining before the softener

signals for regeneration, the number of regenerations in the past 14 days, the total number of regenerations the

control has cycled through and the number of days since the last regeneration.

To enter the service check mode, follow these steps:

Service Check

1. From the Blank display:

2. Press “-” key. The display will blink “FLO” for 3 seconds

and then display the gallons per minute flow rate. This

screen will update the current meter reading every 6

seconds.

Note: This display is only active if the flowmeter is

connected to the valve.

3. Press “-” key. The display will blink “GAL” for 3 seconds

and then displays the gallons remaining before the unit

signals for regeneration (multiply the displayed number by

10).

Note: This display is only active if the flowmeter is

connected to the valve.

4. Press the “-” key. The display will blink “14dY” for 3

seconds and then display the number of regenerations

that have occurred in the last 14 days.

5. Press the “-” key. The display will blink “totL” for 3

seconds and then display the total number of

regenerations this control has cycled through.

6. Press the “-” key. The display will blink “daYS” for 3

seconds and then display the number of days since last

regeneration.

Note: Pressing the “+” key at any time brings back to manual

cycling. Pressing “Status” will Exit the programming menu.

6.4