Specifications

Setting the Microprocessor

The microprocessor senses when it is installed as a Soft-Minder

control. Adding or removing

any connection to the board will automatically reset the microprocessor to the factory

settings.

Step 1 – Programming Time of Day

Press the “STATUS” key.

The display will blink “tod” for 3 seconds and then

change to time of day with the “minutes” digits blinking.

Adjust the “minutes” digits with the “+” or “-” keys.

Press the “REGEN” key to blink the “hours” digits.

Adjust the “hours” digits with the “+” or “-” keys.

Press the “REGEN” key to cycle back to “minutes”

Note: The “hours” setting scrolls through 1-12 AM and 1-12 PM.

Make sure the proper AM or PM indicator is shown when setting the time.

Step 2 – Programming Regeneration Time

Press the “Status” key after setting the time of day.

The display will blink “tor” for 3 seconds and then

change to the time setting with the “ones” digit blinking.

Adjust regeneration time as time of day above.

Note: This option will not show if the “dIP 2” option is set

to immediate

Step 3 – Programming Salt Dosage

Press the “Status” key after programming regeneration

time. The display will blink “SLtP” if set to English or

“SLtG” if set to Metric for 3 seconds and then display

the salt dosage.

Adjust the setting with the “+” or “-” key (3-24 lbs.)

(1-10 kgs.)

Note: This option will not show if the control is set to Filter mode.

Step 4 – Programming Backwash Time

Press the “Status” key after programming salt dosage.

The display will blink “bw” for 3 seconds and then

display the backwash time in minutes.

Adjust the setting with “+” or “-” key. (1-40 minutes)

Programming

i2:00

2:00