Specifications

14
3. Attach motor mount leg (part # 11-0209) to the bearing plate
(part # 11-208), using two of the 3/8” bolts. Place two of the
3/8” bolts through the bearing plate and attach the motor mount
leg securely to it, using one washer per bolt. Slide the 1/4”eye
bolt through the hole on the motor mount leg, place the two
1/4” washers on the eye side of the bolt as shown below.
Tighten the eyebolt down securely, with its 1/4” nylock nut.
4. Attach spring tensioner plate part # 16-0034 to the motor
mount with the remaining 3/8” hardware, the slotted flat face of
the spring tensioner will face the U-shaped bottom of the bear-
ing.