Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Moving Parts Can Cause Severe Personal Injury or Death
- 1.9 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Seismic Requirements
4. Installation2-2016
43A045R241 (Issue 7) Copyright © 2016 Cummins Inc.
• Alternator heater
• Battery warmer
• CCV heater
No. Description
1 AC Distribution Connector(s)
The battery charger, engine coolant heater, alternator heater, CCV heater, and battery
warmer require power from a 120 VAC, 20 amp protected circuit from the Main Distribution
Panel. Use 12 AWG 167 °F (75 °C) conductors to make connection to the generator set AC
distribution connector.
FIGURE 11. AC ACCESSORY CONNECTIONS
DC Connections
NOTICE
When selecting and installing conduit to the generator set, account for any
needed accessories, such as a remote display, etc.