Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Moving Parts Can Cause Severe Personal Injury or Death
- 1.9 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Seismic Requirements
4. Installation 2-2016
46 A045R241 (Issue 7)Copyright © 2016 Cummins Inc.
No. Description No. Description
1 DC Circuit Connectors 5 Remote Start
2 DC Customer Connections (within
Dotted Line Box)
6 Fuse B+ (5A)
3 1302 Control 7 Ready to Load
4 Ground (B-) 8 RA Transfer Switch Terminal Block
FIGURE 14. GENERATOR SET TO RA TRANSFER SWITCH DC CUSTOMER
CONNECTIONS
Drilling Locations for Electrical Connections
Preferred routing of electrical leads is vertically through conduit that is installed in
the mounting pad that terminates in the electrical connection areas. Refer to the
generator set Foundation Outline drawing in the Appendix for location of electrical
connection areas. In some cases, it may be necessary to route electrical leads
horizontally in conduits that pass through the generator set chassis. Refer to the