Product Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 General Safety Precautions
- 1.4 Generator Set Safety Code
- 1.5 Batteries Can Explode
- 1.6 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.7 Fuel and Fumes Are Flammable
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation - PowerCommand 1.1
- 5. Maintenance
- 6. Troubleshooting
- 6.1 Engine Is Difficult to Start or Does Not Start
- 6.2 Code 143 - Engine Oil Pressure Low (Warning)
- 6.3 Code 151 - Engine Coolant Temperature High (Shutdown)
- 6.4 Code 155 - Intake Manifold Temperature High (Shutdown)
- 6.5 Code 197 - Coolant Level Low (Warning)
- 6.6 Code 415 - Engine Oil Pressure Low (Shutdown)
- 6.7 Code 421 - Engine Oil Temperature High (Warning)
- 6.8 Code 441 - Battery Voltage Low (Warning)
- 6.9 Code 488 - Intake Manifold Temperature High (Warning)
- 6.10 Code 1438 - Fail to Crank (Shutdown)
- 6.11 Code 1472 - High AC Current (Shutdown)
- 6.12 Code 5134 - Unknown Shutdown at Idle
- 7. Manufacturing Facilities
2. Introduction 2-2016
12 A045R242 (Issue 7)Copyright © 2016 Cummins Inc.
NOTICE
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
• This device may not cause harmful interferences.
• This device must accept any interference received, including
interference that may cause undesired operation.
2.2 Icons
The following symbols may have been used in this manual to help communicate the
intent of the instructions. They are defined below.
Icon Description
Clean the part or assembly.
Indicates an electrical measurement.
Indicates that an inspection is required.
Indicates an installation or assembly procedure.
Lubricate the part or assembly.
Indicates a mechanical or time measurement.
Refer to another publication for additional information.
Indicates a removal or disassembly step.
Tighten to a specific torque.