Product Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 General Safety Precautions
- 1.4 Generator Set Safety Code
- 1.5 Batteries Can Explode
- 1.6 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.7 Fuel and Fumes Are Flammable
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation - PowerCommand 1.1
- 5. Maintenance
- 6. Troubleshooting
- 6.1 Engine Is Difficult to Start or Does Not Start
- 6.2 Code 143 - Engine Oil Pressure Low (Warning)
- 6.3 Code 151 - Engine Coolant Temperature High (Shutdown)
- 6.4 Code 155 - Intake Manifold Temperature High (Shutdown)
- 6.5 Code 197 - Coolant Level Low (Warning)
- 6.6 Code 415 - Engine Oil Pressure Low (Shutdown)
- 6.7 Code 421 - Engine Oil Temperature High (Warning)
- 6.8 Code 441 - Battery Voltage Low (Warning)
- 6.9 Code 488 - Intake Manifold Temperature High (Warning)
- 6.10 Code 1438 - Fail to Crank (Shutdown)
- 6.11 Code 1472 - High AC Current (Shutdown)
- 6.12 Code 5134 - Unknown Shutdown at Idle
- 7. Manufacturing Facilities
3. Control System 2-2016
36 A045R242 (Issue 7)Copyright © 2016 Cummins Inc.
FIGURE 10. DAYLIGHT SAVING ADJUST END SCREEN
3.5 Brightness and Contrast
The Screen Adjust screen allows the contrast, brightness, and units to be set. To
access the Screen Adjust screen:
1. From any Information screen, hold down the up and down arrows
simultaneously for two seconds to gain access to the Service Menu screen.
2. Select Screen Adjust.
To adjust the contrast, brightness, or units from the Screen Adjust screen:
1. From the Screen Adjust screen, select Adjust to access the screen variables.
2. Press the right arrow to move between the variables.
3. Adjust settings, and press Save to save any changes.
When updating these settings, the functions of the keys are as follows:
• The horizontal right arrow key is used to select successive blocks for editing
settings on the screen.
• Select the left arrow to return to the previous screen.
• Adjust values by using the + or - keys on the Adjust screen of the Display
Setup screen.
• Press Save to save any changes. After saving, the Save button changes to the
Adjust button.