Product Manual

Table Of Contents

5. Maintenance 2-2016

NOTICE

Too much oil can cause high oil consumption. Too little oil can cause severe

engine damage. Keep the oil level between the High and Low marks on the

dipstick.

Adding Oil

If the oil level is found to be insufficient, oil must be added.

1. Ensure that the oil fill cap area is clean, and prevent debris from entering

the engine.

2. Add the appropriate amount of oil, based on the engine oil level check.

3. Recheck the engine oil level. Based on the results, add or drain oil.

4. Clean up and dispose of any oil in accordance with local/state regulations.

Draining Oil

If the oil level is found to be excessive, oil must be drained from the engine.

1. Detach the oil drain hose from the side of the engine.

2. Place the end of the drain hose into an appropriate container.

Refer to local regulations to determine the appropriate container for used oil.

• Open the oil drain valve to release oil from the engine into the appropriate

container.

• Recheck the engine oil level. Based on the results, add or drain oil.

• When a sufficient amount of oil has been drained from the system:

1. Close the oil drain valve.

2. Wipe the oil drain valve clean.

3. Re-attach the drain hose to the side of the engine.

4. Dispose of the used oil in accordance with local/state regulations.

Changing Engine Oil and Oil Filter

WARNING

Toxic Hazard

State and federal agencies have determined that contact with used engine oil

can cause cancer or reproductive toxicity.

Avoid skin contact and breathing of vapors. Use rubber gloves and wash

exposed skin. Accidental or remote starting of the generator set can cause

severe personal injury or death. Disconnect the negative (-) battery cable

and place the control switch in its OFF position before starting work.