Product Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Batteries Can Explode
- 1.5 Moving Parts Can Cause Severe Personal Injury or Death
- 1.6 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.7 Fuel and Fumes Are Flammable
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Manufacturing Facilities
- 4. Control System
- 5. Operation - PowerCommand 1.1
- 6. Maintenance
- 7. Troubleshooting
- 7.2 Engine Is Difficult to Start or Does Not Start
- 7.3 Code 143 - Engine Oil Pressure Low (Warning)
- 7.4 Code 151 - Engine Coolant Temperature High (Shutdown)
- 7.5 Code 155 - Intake Manifold Temperature High (Shutdown)
- 7.6 Code 197 - Coolant Level Low (Warning)
- 7.7 Code 415 - Engine Oil Pressure Low (Shutdown)
- 7.8 Code 441 - Battery Voltage Low (Warning)
- 7.9 Code 488 - Intake Manifold Temperature High (Warning)
- 7.10 Code 1438 - Fail to Crank (Shutdown)
- 7.11 Code 1472 - High AC Current (Shutdown)
- 7.12 Code 5134 - Unknown Shutdown at Idle
5. Operation - PowerCommand 1.1 9-2015
FIGURE 21. TIME REMAINING UNTIL RE-TRANSFER
9. When the utility power is stable for 5 minutes, the transfer switch
switches back to utility power.
FIGURE 22. BUILDING LOAD TRANSFER IN PROCESS
FIGURE 23. UTILITY POWERING BUILDING LOAD
10. The generator set runs for a 5-minute cooldown and shuts off.
FIGURE 24. TIME REMAINING UNTIL STOP
11. Normal operation resumes.
Exercise Sequence
The exercise sequence when the programmed exercise time is realized (the
generator set is in Auto Mode) is as follows:
1. The generator set starts and runs.
54 A051X877 (Issue 3)