Product Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Batteries Can Explode
- 1.5 Moving Parts Can Cause Severe Personal Injury or Death
- 1.6 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.7 Fuel and Fumes Are Flammable
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Manufacturing Facilities
- 4. Control System
- 5. Operation - PowerCommand 1.1
- 6. Maintenance
- 7. Troubleshooting
- 7.2 Engine Is Difficult to Start or Does Not Start
- 7.3 Code 143 - Engine Oil Pressure Low (Warning)
- 7.4 Code 151 - Engine Coolant Temperature High (Shutdown)
- 7.5 Code 155 - Intake Manifold Temperature High (Shutdown)
- 7.6 Code 197 - Coolant Level Low (Warning)
- 7.7 Code 415 - Engine Oil Pressure Low (Shutdown)
- 7.8 Code 441 - Battery Voltage Low (Warning)
- 7.9 Code 488 - Intake Manifold Temperature High (Warning)
- 7.10 Code 1438 - Fail to Crank (Shutdown)
- 7.11 Code 1472 - High AC Current (Shutdown)
- 7.12 Code 5134 - Unknown Shutdown at Idle
9-2015 6. Maintenance
No. Description No. Description
1 Air Cleaner 2 Strap Clamp
FIGURE 39. NORMAL DUTY AIR CLEANER
Heavy Duty Air Cleaner Element Replacement
NOTICE
Cummins Inc. does not recommend cleaning paper-type air cleaner
elements.
1. To remove the existing air cleaner element:
a. Before disassembly, wipe dirt from the cover and the upper portion of the
air cleaner.
b. Lift the latch (3) and turn the end cover (4) counterclockwise.
c. Pull the end cover (4) away from the housing (1).
d. Remove the air filter element (2) from the housing (1).
e. Dispose of the dirty element in accordance with local environmental
agency requirements.
2. To install the replacement air cleaner element:
a. Ensure that no debris enters the filter element or connection point on the
air cleaner housing.
b. Insert the air filter element (2) into the housing (1).
c. Install the end cover (4) onto the housing (1).
d. Turn the end cover (4) clockwise until the latch (3) snaps into place.
A051X877 (Issue 3) 77