Installation Guide

3. Step-By-Step Outline of Installation 1-2014

TABLE 14. IN-HOME DISPLAY MATERIALS

Required Optional

In-home display. One (1) provided with generator. X

Four wall anchors and screws (no. 6) if mounting on stud wall. X

Standoffs and mounting fasteners if mounting on block or brick wall. X

3.1.2.1.1 Loose Parts Shipped With the Generator

The following loose parts are shipped with the generator set:

• Oil drain hose

• Flexible fuel hose assembly

• Welch plug tied to fuel regulator (US GSBB Spec B and Canadian GSBC Spec B only)

• Four base spikes (ground stakes)

• In-home display

• Two keys

• Literature - Operator Manual (A029V089), Installation Manual (A029V088) and Warranty

Statement

3.1.2.2 Tools Required

Use a forklift to move the generator set and set it in place. Alternatively, a one-man hand dolly

designed to fit the generator set base is available to move the generator set and set it in place.

Hand tools required include the following:

• Wire stripper for terminating the communications wires

• Torque wrench

• Jewelers screwdriver

• Allen wrench

• Ratchet set with 10 mm socket and extension

• Two pipe wrenches for gas connections

• Phillips-head and flat-blade screwdrivers

• Ball peen hammer

• Fuel meter (operates down to 5 in. WC)

3.1.3 Choosing A Transfer Switch

Block diagrams showing partial or full load coverage are shown on the following pages:

• UL 1008 listed, Service Entrance Rated Automatic Transfer Switch (without controller):