Installation Guide

1-2014 3. Step-By-Step Outline of Installation
An optional thermostatically controlled battery heater is available for more reliable starting in
ambient temperatures down to -20 °F (-28.8 °C). The heater wraps around the battery. The
heater cord is connected to the 120V, accessory junction box. Install the heater in accordance
with the kit instructions.
To prevent injury due to accidental start-up, do not connect the battery cables to the battery until
the installation has been completed and it is time to start the set.
WARNING
Before working on the generator set, move the Switch (S2) to the Stop Position, disconnect the
remote harness (P7) to disable the ATS mounted charger, and remove the negative (-) battery
cable from the battery to prevent starting.
FIGURE 11. BATTERY INSTALLATION
3.8 Fuel System
WARNING
Fuel systems must be installed by qualified service technicians. Improper installation
presents hazards of fire and improper operation, resulting in severe personal injury or
property damage.
A029V088 (Issue 16) 27