Use and Care Manual

1-2014 3. Operation
• "Genset stopped with return of utility"
• "Switch on genset moved to remote position"
• "Switch on genset moved to run position"
• "Switch on genset moved to off position"
• "Standby ready disabled by user"
• "Standby ready enabled by user"
• "Utility lost - not in Standby Ready"
• "Utility returned - not in Standby Ready"
• "Maintenance reminder - Change oil and check valve lash"
• "Maintenance reminder - Change oil & filter, air filter, adjust valve lash, clean and check
battery & engine cooling fins"
• "Genset fault - (Fault description appended)"
• "Genset warning - Transfer Switch Signal Failure"
• "Genset warning - Transfer Switch Failed to Transfer to Utility"
• "Genset warning - Low Battery or Battery Charger Failure"
3.11 Fault Log
To check the log of the last 5 faults:
1. Press the MENU button on the home screen.
2. Press the up or down arrow button on the menu screen to select Fault Log.
3. Press the ENTER button on the menu screen.
4. Scroll through the fault log with the up and down double-arrow buttons. Each screen
provides a brief description of the fault, the fault code number and the time and date of the
fault.
5. Press the BACK button to return to the home screen
NOTICE
If there are no faults recorded, the “No Stored Faults" screen will appear.
A029V089 (Issue 9) 27