Product Manual

5. Startup and Configuration 2-2017

5.2 InPower Service Tool

The InPower

service tool can be used in troubleshooting to perform tests, verify

control inputs and outputs, and test protective functions. Refer to the InPower

User's Guide, provided with the InPower software for test procedures.

5.3 Checklist

Tick General Items

Generator set wattage capacity is sufficient to handle maximum anticipated load.

At least 3 feet (914.4 mm) of clearance (or greater for housing door) is provided

around the entire generator set for service and ventilation.

The generator set is located in an area not subject to flooding.

All operating personnel have read and are familiar with the generator set Operator

manual, all health and safety procedures, warnings, cautions, precautions, and the

other documentation supplied with the generator set.

All operators have been thoroughly briefed on preventative maintenance procedures.

All operators have read and understand all important safety instructions.

Generator Set Support

The floor, roof, or earth on which the generator set rests is strong enough and will not

allow shifting or movement. Observe local codes on soil bearing capacity due to

freezing and thawing.

The generator set is properly supported and retained to an approved base

The supporting base is large enough and is of non-combustible material, extending 6

inches (152.4 mm) all around the generator set.

Cooling Air Flow

Generator set air inlet is faced into direction of strongest, prevailing winds.

Air inlet openings are unrestricted and are at least 1 to 1

times larger than air outlet

area.

Cooling air outlet is on downwind side of building (if not, wind barrier is constructed).

Proper ducting material (sheet metal, canvas) is used between radiator and air outlet.

Diesel Fuel System

Fuel tanks meet or exceed all Local, State, or National codes (if applicable).

Fuel lines are properly installed, supported, and protected against damage.

The fuel filters have been installed.