Installation manual

Page 1
Operation and Installation Manual
PN 018-01049 Rev 1.6c
Energy Command 30
General
The Energy Command 30 (EC-30) is an Automatic
Generator Starting (AGS) System that provides both
automatic and manual control of Onan Diesel, Gasoline,
and Liquid Propane (LP) engine driven AC generators
(referred to in this manual as a genset). EC-30 also
provides critical system information such as the battery
state-of-charge, key operational information such as
quiet time, genset service and fault messages. EC-30
automatically starts the genset when the battery
becomes discharged or when there is a run request
from an external device such as a Heating Ventilating
and Air Conditioning (HVAC) system. When the battery
is charged, or the HVAC system no longer requires
power, the genset is automatically turned off.
This system is only for use with Onan Recreational
Vehicle genset (Quiet Diesel gensets, and
Gasoline/LP gensets).
For personal safety and to avoid equipment
damage;
Thoroughly read and understand this
Operation and Installation Manual before
using or installing.
The EC-30 should be installed by qualified
persons following wiring and installation
details provided in this Operation and
Installation Manual
If these instructions conflict with the genset
manuals, the genset manuals should take
precedence.
Keep these instructions with the genset
manuals.
AGS Safety Precautions
Exposure to carbon monoxide, moving parts, and
electricity hazards is possible due to unexpected
automatic starting.
!!WARNING!!
CARBON MONOXIDE is deadly! MOVING
PARTS and ELECTRICITY can cause severe
personal injury or death. To reduce exposure
to these hazards, always disable AGS before
:
Sleeping in vehicle, unless vehicle has a
working CARBON MONOXIDE detector
Parking vehicle in garage or confined
space
Parking vehicle for storage
Servicing genset
Servicing batteries
Servicing electrical appliances
Fueling vehicle.
Before storing or servicing, disable AGS by
disconnecting battery or genset remote harness.