Installation manual

Page 6
The SERVICE DUE message is displayed as soon
as the service interval has elapsed. The
UP/DOWN key still allows navigation through the
main displays and all functions still work. After
the genset is serviced navigate to the SERVICE
DUE message and ENTER to reset the service
interval hour-meter.
If the genset is serviced prior to the next service
reminder, go to the SERVICE IN display and press
SET, press ENTER to reset the service interval
hour-meter.
The SERVICE IN display is also used to display
genset faults and errors that may occur. If a fault
or error has occurred, it will be displayed even if it
no longer exists. When any key is pressed the
message will be cleared.
The last fault message may be displayed by
pressing the STOP switch three times. See the
genset operating manual for details on the error
codes and messages.
Genset Hour-meter
The genset hour meter displays the total elapsed
time the genset has run since the EC-30 was
installed. If the EC-30 is installed on an existing
generator, see the SETUP section of this manual.